Recommended replacement period

1. It is recommended to change the fluid once a month and a half in high temperature and rainy season in summer.

2. The fluid change cycle in winter can reach more than three months.

3. In other seasons, change the cutting fluid once every two months.

Precautions for the use of cutting fluid

1. When replacing the cutting fluid of the machine tool, the original cutting fluid must be poured clean and thoroughly cleaned; otherwise, the original residual cutting fluid that has deteriorated may cause rapid deterioration of the newly replaced cutting fluid.

2. When adding cutting fluid during the production process, be sure to add it according to the use proportion in the manual. Do not only add water without cutting fluid, otherwise it may cause the product to rust.

3. After the original cutting fluid is mixed with water and added to the machine tool, it should not be left unused for a long time. When the machine tool is not in production, it is best to open the pump to circulate the cutting fluid for 30 minutes every day.

Reasons for rapid rusting of products during production

1. The use ratio is insufficient, and the ratio is not added according to the requirements of the manual.

2. The cutting fluid has deteriorated, and the performance of deterioration is that the pH value has dropped drastically, and there may be peculiar smell.

3. The easiest way for users to solve the problems in the use of cutting fluid is to pour all the original cutting fluid of the machine tool, clean it thoroughly, and then re-formulate and add it according to the ratio required by the manual.

This article is from East Asia Petrochemical（http://www.fable-china.com/newsview/536.html）,Please indicate the source